Emergency Fire Protection Unit

• 2500 GPM @ 150 PSI; ITT A-C Model 10x8x20F-L

• 60 foot flexible suction line

• Diaphragm type manual suction line priming pump

• (3) 6 in. suction connections with low drafting adapter

• (2) 2.5 in. threaded or (3) 5 in. storz discharge connections

• Panel mounted suction and discharge gauges

• Leased with or without a certified operator

• Delivered nationwide

Click Here to Download a Product Bulletin

13-R Residential Fire Pump System

• In Compliance with NFPA 13-R and NFPA 20

• CIBF Pump Construction

• Hydrostatic & Certified Performance Test on Pump Unit

• ODP JP Shaft Motor; 5.0 & 7.5 hp, 230 v / 1 ph / 60 Hz

• UL listed flow switch with remote contacts

• UL listed / FM approved suction and discharge control valves

• Check valve and manual inspection test valve

• Auto-start / auto-stop on pressure drop / restoration

• Pre-mounted, pre-wired control panel in a Nema 1 enclosure containing a minimum run period timer

• Options: Flow meter loop, City water by-pass, 3-Phase Motor

Click Here to Download a Product Bulletin

1500 GPM In-Line Fire Pump

• 10 Pipe diameters of straight suction pipe is not required
• Compact, self-contained, self-venting design
• Requires 30% less space than a horizontal split case pump
• Easy to install requiring about 50% less installation time
• Capable of being mounted vertically
• Suction and Discharge flanges are on the same centerline
• Requires no base, coupling, or guard eliminating special pads, foundations, or bases in most cases
• Motor can rotate for easy accessibility to the junction box
• With only one stuffing box, leakage is reduced by 50%
• Bearing free pump design
• No field alignment is required because the impeller mounts directly to the motor shaft that pulls out for easy maintenance

Click the links below to Download a Product Bulletin

1500 GPM @ 66 PSI - 80 PSI / Model 8x8x13.5F

1500 GPM @ 81 PSI - 124 PSI / Model 8x8x18F

Cast / Grooved Test Header

• In compliance with NFPA 20 flow testing requirements
• Grooved connection - no need for adapter flanges
• 4 in., 6 in., 8 in., and 10 in. sizes
• Suitable for 500 GPM to 3500 GPM fire pump applications up to 300 PSI working pressure
• Cost advantage to other standard hose header designs
• Cast iron construction
• Saves a lot of installation time

Click Here to Download a Product Bulletin

150 lb. Flange Adapter

• In compliance with NFPA 20
• 150 lb. flat faced flange with grooved end rated for 300 PSI working pressure
• Space saving design
• 4x4 in., 4x6 in., 6x6 in., 6x8 in., 8x8 in., and 8x10 in.
• Provides grooved connection at the pump discharge
• Can be used as a concentric discharge increaser
• Significant cost savings over alternate designs
• Saves a lot of installation time
• No more wasted time installing additional flanged connections

Click Here to Download a Product Bulletin

13-D Packaged Pump System

• In compliance with NFPA 20

• Rated for 20 - 50 GPM @ 30 - 55 PSI

Click Here to Request Information on This Product